Files (2)

04-06_Pontiac_GTO_Windshield_Wiper_Arm_Grommet_Cover_Cap_-_Holden_Logo.stl

STL

1.6 MB

04-06_Pontiac_GTO_Windshield_Wiper_Arm_Grommet_Cover_Cap_-_Plain.stl

STL

1.4 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
04-06_Pontiac_GTO_Windshield_Wiper_Arm_Grommet_Cover_Cap_-_Holden_Logo.stl	Cover / cap	1.6 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
04-06_Pontiac_GTO_Windshield_Wiper_Arm_Grommet_Cover_Cap_-_Plain.stl	Cover / cap	1.4 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trim Pieces

04-06 Pontiac GTO Windshield Wiper Arm Grommet Cover Cap

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Created this cap to replace the rubber grommet GM part# 92054485 because they're ridiculously expensive at over $20 for a single rubber cap. This is the part without supports, ready for your slicer app. I used Lychee.