Files (1)

2002_Toyota_Tundra_Heater_Knob.stl

STL

76.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 90%	100% solid	Recommendation
2002_Toyota_Tundra_Heater_Knob.stl	Primary model	76.7 KB STL	Slice file	Slice file	Slice file	Print with the knob handle down and the connector pointing up for optimal results

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

2002 Toyota Tundra Heater Knob

0 downloads36 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement for the heater control knob in a 2002 Toyota Tundra. This original model was based on the actual knob, with some simplification of the grip for printing. It should print well with the knob handle down and the connector pointing up, though you may choose to anchor it with a brim or raft. It was tested in the actual vehicle and it worked perfectly. I would suggest using 100% infill for strength, but the connector part that plugs onto the shaft is pretty much solid by default due to the thickness of the walls, so it's probably not necessary.