2013-2019 Ford Fusion/Mondeo screwless phone mount - image

Files (2)

Fusion_bracket.stl

STL

37.0 KB

Fusion_mount_clip_bracketron.stl

STL

53.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Fusion_bracket.stl	Mount / bracket	37.0 KB STL	Slice file	Slice file	Slice file	Print the bracket with the flat side down
Fusion_mount_clip_bracketron.stl	Clip	53.2 KB STL	Slice file	Slice file	Slice file	Print the bracket with the flat side down

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

2013-2019 Ford Fusion/Mondeo screwless phone mount

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a snap-in bracket for the Ford Fusion/Mondeo, designed to fit out of the way and not require any screws! The bracket will snap in, but you may want to gently nudge the radio surround trim a little to prevent breaking the tabs. Initially I printed with PLA, but learned a California Summer pretty much liquidifies PLA. So I tried again with PETG with better results. Drill the holes out on the bracket with a #40 drill bit and tap for a 4-40 or M3, and use either a M3x4 or 4-40 x 1/4" screw to mount together. I did not use inserts or nuts. I included a hole through the push-tab to mount the lower screw (if you are using the slide-on bracketron/Dynex mount like I am). Print at highest 0.12 resolution. I printed at 0.08 with great results and adhesion. Bracket: print with flat side down, enable supports bracketron adapter: print on its side for best strength in the release clip. Hope this helps!

Compatible Cars

Ford Fusion

Published Jun 27, 2026Updated Jul 15, 2026

Originally published on thingiverse.com by Will Foley (corvettephreek) · License: CC BY

Verified by drivers

Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.

Loading fitment proof…

Comments (0)

Part lists

Save this part to named public or private collections. Public lists can be shown on this part page.

Related Parts

Finding specific fitment/category matches first.