Files (1)

7QBIYh8jb3x.stl

STL

474.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
7QBIYh8jb3x.stl	Primary model	474.2 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level and clean for a strong adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

21+ F150 Magsafe charging stand

0 downloads141 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/7QBIYh8jb3x The block at the top on the back is for some velcro, so it will stay in place inside the console under the heat controls. I have the object to print as a whole, or two pieces. I found it easier to print as two, and then glue together. But you do you:) Print it, use it, post a pictures, or remix it. I have decided I put enough time into this. But if someone makes it better, I just might print it out myself. The magsafe charger fits in the hole, but it is tight, I sanded the inside to make it slide in better. I was going to make the hold like.1mm bigger, but decided to just sand it out a little bit instead of waiting another for another 15 hour print.