Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ABS 20%	PETG / ABS 30%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

2nd Gen Tacoma Low Profile Ditch Light Bracket

0 downloads25 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Low profile ditch light bracket for 2nd Gen (2005-2015) Toyota Tacoma. Mounts to hood hinges with factory hardware. I printed at 80% infill with tri-hexagon pattern on ender E3 and it has been strong enough. Mounting location gives about 1.5 inches horizontally to the windshield from the center of the bolt hole with the hood up. That said, choose your lights accordingly. Print from a durable plastic (ABS, PETG). I have one from PLA and it's holding up. So, it may be good enough in PLA. UPDATE: The PLA began to sag causing the lights to tilt sideways. I reprinted in ABS with a 0.8 nozzle, 2 walls, 30% infill, and it's holding up to the summer temperatures well. Use at your own risk to persons and property. Install instructions: 1) Remove the upper bolt that mounts the hood to the hinge. 2) Attach ditch light mount crooked and reinstall the bolt. Tighten snugly. 3) Remove the lower bolt and swing ditch light bracket into place. 4) Reinstall lower hood mounting bolt. 5) Torque down both bolts. 6) Install ditch lights 7) Repeat on opposite side.