98-00 Toyota Corolla / Geo Prizm Rear Cup Holder Arm - image

Files (2)

CE3_Corolla_Cup_Holder_Arm.stl

STL

1.6 MB

Corolla_Cup_Holder_Arm.stl

STL

310.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
CE3_Corolla_Cup_Holder_Arm.stl	Mount / bracket	1.6 MB STL	Slice file	Slice file	Slice file	Ensure a brim or raft is used for better adhesion
Corolla_Cup_Holder_Arm.stl	Mount / bracket	310.2 KB STL	Slice file	Slice file	Slice file	Ensure a brim or raft is used for better adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

98-00 Toyota Corolla / Geo Prizm Rear Cup Holder Arm

0 downloads79 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The cup holder arm broke on a friends 99 Toyota Corolla rear cup holder. This is a super cheezy replacement. I'm new to 3d modeling, so it isn't clean at all, but it does work. The stock arm used springs on either side, but this one doesn't use the spring. You just pull it up when you want to use it. Hope it proves useful.