Files (2)

clip_3.stl

STL

59.5 KB

dash_clip_1.stl

STL

52.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
clip_3.stl	Clip	59.5 KB STL	Slice file	Slice file	Slice file	Print with the opening facing up and down to minimize reliance on layer adhesion
dash_clip_1.stl	Clip	52.4 KB STL	Slice file	Slice file	Slice file	Print with the opening facing up and down to minimize reliance on layer adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

bmw dash clip

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The dashboard panel around the start button in my e92 began falling off due to a failed clip. I left it like this for quite awhile then the passenger door wood panel also fell off so I decided to design both clips to replace the broken ones as they cost more money than im willing to pay for original and aem ones dont last one use. I printed them with support on their sides so the opening is going up and down as this doesnt rely on layer adhesion for strength. "dash clip 1" is the dash clip "clip 3" is the door clip.