C5 Corvette Under Hood Light Cover - image

Files (1)

C5-Corvette-Hood-Dome.stl

STL

49.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
C5-Corvette-Hood-Dome.stl	Primary model	49.9 KB STL	Slice file	Slice file	Slice file	Ensure proper ventilation when printing with PETG or ASA

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

C5 Corvette Under Hood Light Cover

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement lens for the 1997 - 2004 C5 Corvette under hood light. It is not an exact replacement, but it fits fine. It prints in a couple hours. It will get hot under there so make sure you use PETG or ABS. I used PETG, haven't really put it to the test yet. Will do that later today. If anything negative occurs will post and fix. I cut a piece of clear printer mylar - 57mm x 44mm and super glued it inside to help make it water resistant. Hope this helps someone else. 11/6 - version 2 uploaded. It has thin holes instead of through holes. Cleaned up the edges a bit too. It may not be as bright, but it is more waterproof.