Files (1)

CupHolderPad_70.5_Challenger.stl

STL

334.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 40%	100% solid	Recommendation
CupHolderPad_70.5_Challenger.stl	Mount / bracket	334.7 KB STL	Slice file	Slice file	Slice file	Print two inserts for both cup slots

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Challenger Cup Holder Insert

0 downloads36 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Insert for the front cup holder of 2012 Dodge Challenger. Both cup slots are the same size, print 2 inserts. I could have added an extra 0.5mm but as is gives it a very good fit. If as I use it I find it creates a vacuum and wants to pull the insert up with the cup I may print again slightly larger for a friction fit or add some texture to the top to eliminate a vacuum. Will update the print if I find this to be an issue. The little lift tab I designed onto it prints fine on my printer, slowing the layers down a little on the last few can help it turn out better. Really is not critical, just gives you something to grab onto with needle nose if it is stubborn to remove. I printed with 20% infill however it is so thin it really does not have infill so this parameter should not matter. Printed with TPU. A rigid material may need small size adjustments.