Chevrolet key fob protector - 1999 2008 Tahoe and other models - image

Files (1)

tahoekeyfob_fixed.stl

STL

244.4 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
tahoekeyfob_fixed.stl	Primary model	244.4 KB STL	46g $1.10	50g $1.20	110g $2.63	Ensure a snug fit by adjusting the model's scale if necessary

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Accessories

Chevrolet key fob protector - 1999 2008 Tahoe and other models

0 downloads170 views0 likes

Shared by

Michael Chen

Verified

Description

I have a 1999 and 2006 Chevrolet Tahoe. The key fob/unlocker remote doohickey has the same profile on both. I wanted something that would make them a bit different, so it would be easy to grab the right one. As a added bonus, it keeps one of the previously broken fobs with a cracked case held together held together quite nicely. I might make this a bit thinner and less tall next time a round, but it works just fine as is. This will likely fit other Chevy/GMC vehicles as well. Just shove it onto the fob, it is a snap fit.