Files (1)

brakecap.stl

STL

286.0 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
brakecap.stl	Cover / cap	286.0 KB STL	46g $1.10	50g $1.20	110g $2.63	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Accessories

Chevy Brake Reservoir Cap

0 downloads253 views0 likes

Shared by

Michael Chen

Verified

Description

Cap that fits GMT800 trucks. Designed specifically for my Avalanche, should also fit Silverado, Tahoe, Suburban, Sierra, Yukon, and Escalade from 99-06. Bought a truck that didn't have a cap, and no stores had them in stock near me, and nobody on here had designed one yet, so I dusted the cobwebs off my 3d design skills and whipped this up. Almost perfect replica of the actual cap. Please note, it still needs the rubber membrane to fully seal. Maybe just cut one from a piece of scrap rubber, idk. And keep in mind the effects of brake fluid when it comes in to contact with different kinds of plastic. Maybe I'll design one that seals without the rubber. But for now enjoy this, hope it helps. Chevrolet GMT800 Avalanche Suburban Silverado Tahoe Sierra Yukon Escalade BrakeCap Brake Cap Brake Fluid Reservoir Master Cylinder gmt800 Avalanche Tahoe Suburban Silverado.