Citroen, Peugeot rear cable sleeve clip - image

Files (1)

citroen_cable_clip.stl

STL

54.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
citroen_cable_clip.stl	Clip	54.2 KB STL	Slice file	Slice file	Slice file	Print two clips as they lock into each other

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Citroen, Peugeot rear cable sleeve clip

0 downloads36 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement clip for my Citroen C4 (2007) Coupe cable sleeve at the boot. Since there was a problem with the cables (they would brake every now and then and cause shortcuts) removing the cable sometimes results in braking this little piece that is essential to hold the cable sleeve (FYI: my mechanic broke it and had it super glued, so after a while the whole sleeve would come off!). It's a replacement part that you cannot find anywhere (or no one would sell it to me!), so I had to print one. The Citroen order code for this is: 96308075.80. You will need to print 2 of those since one locks to each other (the locking is not great but a little bit of super glue to each other gets the job done). Enjoy!:) Many thanks to kold for designing it in Fusion!!