Files (1)

clio_Cup.stl

STL

1.7 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
clio_Cup.stl	Primary model	1.7 MB STL	Slice file	Slice file	Slice file	Ensure the model is oriented to minimize supports, if needed

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Clio mk2 cupholder v3

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is v3 of my cupholder I planned to make and sell but as I don't have the time I'm releasing the file for free. picture is from v1 (hence the rough print) design parameters are as follows: mcdonalds cups of all sizes fit and do not move. 330ml cans fit and do not move. positioned in front of the fans to allow heat/AC to keep drink correct temp. avoid wiper stalk and door card. replace existing plastic trim with no extra hardware. F3D file included for editing. check print settings section for how to print.