Console pocket hook for Toyota Camry - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

Console pocket hook for Toyota Camry

0 downloads53 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a hook I designed to fit the small pocket on the side of the console in my 2008 Toyota Camry SE (May fit other Camry models manufactured in 2006-2013 years - see Photos to check if your console has those pockets). The hook is intended to fit in the passenger-side pocket and hold a thin cellophane shopping bag to be reused as a trash bag. The LG hook can support larger bags, such as the slightly thicker ones marketed as "reusable". The hook fits snuggly to the pocket, and has to be put in towards the upper part of the pocket where the lip is slanted a touch more than at the bottom. It is very snug to the pocket lip so it does not come off when you go to swap out the bag. The part holding the bag itself is tight enough to hold on to the bag, but open enough so that switching out the bags isn't a pain. It's been a huge help for road trips!