Files (2)

cromodora_center_cap.stl

STL

63.9 KB

Cromodora_Center_Cap_X19.stl

STL

82.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
cromodora_center_cap.stl	Cover / cap	63.9 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
Cromodora_Center_Cap_X19.stl	Cover / cap	82.6 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cromodora Center Cap

0 downloads36 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I had some Cromodora 5 spoke wheels on my Alfa GTC, but only had 3 of the Alfa Romeo Center caps. So I made a center cap copy in Tinkercad and this is it. I also made a version with a recessed X1/9 text for the guy who bought my wheels for his Fiat X 1/9. These just snap into place in the 42mm hole in the wheel. I made them flat so they could have something glued to them. The recessed ones can be highlight painted. I printed these in ABS, on a Flash Forge Creator Pro with a glass bed. I set the print up for 2 shells (in addition to the perimeter) and 25% infill. That used 4.74 meters of 1.75mm filament.