Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| rev_truck-radio.stl | Primary model | 54.6 KB STL | Slice file | Slice file | Slice file | Ensure a strong adhesion to the print bed to prevent warping |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Double din to Single din with aux switch mount hole
Shared by
3DPrintedCarPartDescription
Remixed to fit my 2003 Ford Ranger because I needed a place to mount the switch for my new Off-Road lights. I am using a rear support on the receiver from my previous universal double din adapter kit, as well as the bezel that came with my receiver. The clips could be better, but do a good job of holding it in there as is. Whenever I get around to adding more switches and replacing this again I will improve upon that. The switch mount hole is sized at 20.5 mm diameter to fit the switch that came with my harness kit.
Compatible Cars
Originally published on thingiverse.com by (DustyDingus) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
