Files (1)

RadioCap.stl

STL

143.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 15%	100% solid	Recommendation
RadioCap.stl	Cover / cap	143.8 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and supports unlikely.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Equalizer knobs for GM radio

0 downloads27 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The original knobs on the radio all split down the middle, so after trying unsuccessfully to find more in various junkyards, I decided to design new ones and print them. After they were done, I put some white paint I had laying around and brushed some into the recessed line to see where it was pointing better. Each one only takes around 4 minutes to print on a slower speed, use high resolution, infill doesn't really matter. It uses the original tension clips that go on the knob post, so make sure you take them out of the original knobs or off of the post before trying to put them on.