Ford FITS Blank Plug (2022 Ford Maverick) - image

Files (1)

Ford_FITS_Blank_Plug.stl

STL

179.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Ford_FITS_Blank_Plug.stl	Primary model	179.0 KB STL	Slice file	Slice file	Slice file	Use a heated bed for better adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Ford FITS Blank Plug (2022 Ford Maverick)

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a blank plug designed to fit into and fill a 2022 Ford Maverick FITS Slot. I had some fitment problems on the sides of my FITS slots so the dimensions have been slightly modified and I added "Ford" text to the front of the model. If you have issues utilizing the model I remixed this from, give this one a try. I printed this on a Creality Ender 3 with eSUN PETG using the following settings: Print Temperature: 245 Plate Temperature (Initial Layer): 80 Plate Temperature: 70 The rest of my settings were autoapplied via the eSun Black PETG with 0.4mm nozzle extruder settings in Cura 4.13. Print time total was 1 hour 18 minutes. Fitment was tested in rear center console and under back seat. No wiggle, solid hold, no removal problems. Original Model: https://www.thingiverse.com/thing:5114828