Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| Ford_FITS_LP_Cupholder_With_Cable_Mount.stl | Mount / bracket | 226.8 KB STL | Slice file | Slice file | Slice file | Ensure proper adhesion to the print bed to prevent warping |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Ford FITS LP Cupholder With Cable Mount (2022 Ford Maverick)
Shared by
3DPrintedCarPartDescription
This is remix of the low profile cupholder done by RedBaron97. I added a 3M cable grabber onto the flat section I added between the cupholder holes so I could route a cable for charging an android tablet / phone on the road. I printed this on a Creality Ender 3 with eSUN PETG using the following settings: Print Temperature: 245 Plate Temperature (Initial Layer): 80 Plate Temperature: 70 The rest of my settings were autoapplied via the eSun Black PETG with 0.4mm nozzle extruder settings in Cura 4.13. Print time total was 8 hours 52 minutes. Fitment was tested in rear center console slot. Original Model: https://www.thingiverse.com/thing:5114828
Compatible Cars
Originally published on thingiverse.com by John Klockenkemper (Kl0ck) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
