Files (3)

focusbadge_mk1.STL

STL

360.5 KB

focus_badge_mid_pin.STL

STL

36.9 KB

focus_badge_side_pins.STL

STL

19.3 KB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
focusbadge_mk1.STL	Printable file	360.5 KB STL	Slice file	Slice file	Slice file	Print the badge with the Ford logo on top for easier printing of in-set letters
focus_badge_mid_pin.STL	Printable file	36.9 KB STL	Slice file	Slice file	Slice file	Print the badge with the Ford logo on top for easier printing of in-set letters
focus_badge_side_pins.STL	Accessory piece	19.3 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

Ford Focus ST 2015+ Front Badge

0 downloads202 views0 likes

Shared by

Michael Chen

Verified

Description

A Ford badge made to replace the front bumper badge of a 2015+ focus st. I made it after I bought a new bumper for a front-end conversion. It was supposed to be temporary but it's been over a year and it's still solid in place. I printed the badge with the ford logo on the top and the pin side on the bed. I think this makes the in-set letters easier to print. Shouldn't really need support for the edge but they wouldn't hurt. Print the pins with the flat tip on the bed. After printing, use some sort of liquid adhesive (glue, epoxy) to attach the pins to the badge. Middle pin in the middle, others on the sides. (I didn't end up using the side pins but they might be useful) Check the holes in your bumper to determine how to orient the pin clasps. (they go vertically so the long sides of the pin should be perpendicular to the logo) The pins are primarily for alignment on the bumper. To attach the badge to the bumper, use some thin double-sided tape or any other form of adhesive you're comfortable with.