Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| AccessPort_Mount_-_Focus_ST.stl | Mount / bracket | 186.0 KB STL | Slice file | Slice file | Slice file | Use a brim for better adhesion |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Ford Focus ST RS - Cobb AccessPort mount - A Pillar
Shared by
3DPrintedCarPartDescription
After several iterations, with varying degrees of angle, i've settled on a design i like. This is based on the right-hand drive version by shaddsi. (thanks!) It's been flipped for US/left-hand drive, and modified to use the new mount design for the accessport holder. works great, though it's hard to get both sides clipped in. I've found the rubber molding around the door holds one side in well, and allows sliding it up and down some on the A pillar for adjustment. As with shaddsi's model, i recommend ABS, and a good size BRIM. I was able to print this on my MONOPRICE Mini 2. It's just under 110mm across. If you wish to get an editable version, check here: TINKERCAD LINK
Compatible Cars
Originally published on thingiverse.com by Jeremy Brovage (jbrovage) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
