Ford Maverick Trailer Control Switch Panel preview

Files (1)

16mm One Hole.stl

STL

56.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
16mm One Hole.stl	Primary model	56.3 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Ford Maverick Trailer Control Switch Panel

0 downloads48 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in car conditions

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY-SA

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

I just installed the Diode Dynamics foglight kit on my 2022-2024 Ford Maverick hybrid, and now I want a good spot for the switch that goes into the cab. I decided I don't want to cut a hole in my factory trim so after doing some research, I learned that someone from the MTC forums has had success using the lower trim from a 4k tow which has the cutout for the trailer controls. Ford part number is NZ6Z-2604459-BA. I have uploaded STLs of single and dual cutouts for 16mm and 19mm round switches, plus a blank one if you'd like to cut the holes yourself. I also included the Fusion 360 files since I did try to design this parametrically. The clips may be a little tight, but take note the top ones are square and are meant to “hook in” first, then you clip the bottom ones which are beveled a bit. You may have to deburr or trim the cutouts after printing, especially if you have seams set to aligned, at least that was the case with my prints. Enjoy!