Files (1)

ford_holder_02.stl

STL

7.1 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
ford_holder_02.stl	Mount / bracket	7.1 MB STL	Slice file	Slice file	Slice file	Print with the clips section at the back facing upwards for maximum strength

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

ford_ranger_mobile_holder

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Hi i have uploaded a mobile phone holder, for my Ford Ranger 2006 truck, always had an issue with a place to put my phone. it clips onto the rear view mirror. for the moment it seems to work pretty well. couple notes: i had to adjust my printer parameters for overall height as the part finishes off at 110mm, something out might have to adjust. the reason a printed it upright was is could the most strength for the clips section at the back. the photo and the part is slightly different as I had a few issues which i picked up from the first print when testing, so i have tweaked it slightly for a better fit, had to allow for the button at the bottom of the phone, which i missed in the first print. this has been design to accommodated a Samsung S7 with cover (pure.gear), i have tested with a few other mobile phones it does work, Iphone users will need to adjust the overall width as it does slip out. enjoy...