Ford Ranger Window Crank Bushing - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 40%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Ford Ranger Window Crank Bushing

0 downloads34 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

While Driving around I noticed a rattling noise coming from my door in my 2008 Ford Ranger. It turns out the window crank mechanism had worn with age and had some play in it. I printed this bushing to press around the crank spline shaft and haven't had any rattling since. To install, remove the window crank handle with a long T20 bit, then simply push the bushing into place (short end goes in first). If it doesn't slide in all the way (mine didn't because I wanted it to be a snug fit) just get it on enough to get the crank handle screw started, then tightening down that screw will push the bushing the rest of the way in place You do not need to remove the door card. the bushing will slip through the existing hole. I did not notice any difference in terms of resistance when raising and lowering the window.