Files (1)

fordedgeclips.stl

STL

11.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
fordedgeclips.stl	Clip	11.4 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

FordEdgeClips

0 downloads40 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/hO03kdXYThL I just bought a 2017 Ford Edge and at 65MPH on a windy day I noticed a loud vibrating sound from the bottom of the car. There is a splash shield under the car that runs on both sides from front axle to back axle. When I would move that with my hand I noticed it sounded very loud and loose in the middle. (I tested a 2015 for this issue and it was tight) So I figured mine just had worn out mounting clips. I printed these clips to fill the gap between the Ford mounting clip and the shroud. I hope this helps and will report back the results if the sound goes away. THE SOUND DID GO AWAY!