Files (2)

Adapter_M4.stl

STL

605.9 KB

Adapter_M6.stl

STL

607.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Adapter_M4.stl	Printable file	605.9 KB STL	Slice file	Slice file	Slice file	Ensure proper fitment by scaling the part in the slicer if necessary
Adapter_M6.stl	Printable file	607.1 KB STL	Slice file	Slice file	Slice file	Ensure proper fitment by scaling the part in the slicer if necessary

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Giulietta JDM shifter adapter

0 downloads38 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is an adapter that adepts the standard Giulietta shift rod to the JDM shifters you can buy everywhere. - M6 or M4 If you are not stupid and you have not ripped of the thread off your shift rod, like I did, you can download the M6 version and secure the adapter with the nut of the original shift knob. But if you are stupid and have ripped off your thread you can drill a 3,5mm hole and cut a thread in the center of the shift rod and screw the adapter down with a M4 screw. - Fitment The part is optimized for the tolarences of my ender 3. If it does not fit over your shift rod or it has play, try to uniformly scale the part up or down by a few percent in your slicer.