Jeep Cherokee XJ pre face-lift cup holder - image

Files (1)

Cup_Holder_XJ.stl

STL

70.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Cup_Holder_XJ.stl	Mount / bracket	70.2 KB STL	Slice file	Slice file	Slice file	Ensure proper fitment by drilling 3 holes into the center console as instructed

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Jeep Cherokee XJ pre face-lift cup holder

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I decided to make this as I hated the aftermarket cup holder that goes over the handbrake. This design requires 3 holes to be drilled into the center console for fitment. When in place it sits over the transfer case selector lever so is only usable when in 2WD. Having slots for the screws to sit in, it simply lifts up and out of the way when 4WD is required. This should fit most, if not all standard UK fast food cup sizes but was designed with McDonalds large cups as my template with wriggle room. The largest base of as cup it could take is 65mm.