Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| No printable model files are available for an estimate yet. | ||||||
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Jeep Grand Cherokee WK Switch Plate / Panel
Shared by
3DPrintedCarPartDescription
Switch panel that replaces the factory cubby on left side of dash. Fits five 3/4 inch switches made to fit Hella switch #H61923001. The cheap push in rocker switches on Amazon will fit but don't like to stay in, (well at least the ones i have) The part is 1/8 thick. Should fit Jeep Grand Cherokee Wk 2008-2010. Possibly Jeep Commander of the same years. (If someone tries let me know.) Actual part dimensions 144mm long, 58mm tall, 3mm thick, holes 20mm. Not perfect but works good for now. The tabs are a tight fit be careful removing it after test fitting, once the switches are in you will more than likely have to push it out from the back. ---The square hole one has NOT been tested I was asked to add it. Hole size is 25mm x 48mm---.
Compatible Cars
Originally published on thingiverse.com by Dennis Spears (OneWinner) · License: CC BY-NC-SA
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
