Jeep Wrangler 5 Speed Shift knob M10x1.5 thread - image

Files (1)

Jeep_5spd.stl

STL

2.2 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 35%	100% solid	Recommendation
Jeep_5spd.stl	Primary model	2.2 MB STL	Slice file	Slice file	Slice file	Print with the threaded hole facing down for a nicely finished top

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Jeep Wrangler 5 Speed Shift knob M10x1.5 thread

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Shift knob for my 2003 Jeep TJ Rubicon. This is for the 5 speed NV3550 but may also fit other models with the Metric M10x1.5 thread. Print with the threaded hole facing down, will leave the top of the knob nicely finished. Once done, just clean up the threads with a tap. I printed with 50% infill, but you can go lighter if you wish or heavier, depending on your personal preference. I used PLA but you can also use other materials......hmmm maybe I should print one with PLA/Carbon;).