Jeep Wrangler hard top quick-release knob - image

Files (1)

HardTopKnob.stl

STL

3.0 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
HardTopKnob.stl	Primary model	3.0 MB STL	Slice file	Slice file	Slice file	Ensure the knob head is large enough for easy grip and handling.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Jeep Wrangler hard top quick-release knob

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I wanted to install quick-release knobs on my Jeep TJ to simplify taking the hardtop off. There's lots of cheap bolt kits on eBay and Amazon, but I didn't care for the fact that the heads are all small. I wanted nice large knob heads to make it easy, and kits with large knobs were too expensive. So I whipped these up in an afternoon. The design receives an M8x35 bolt. I purchased them from Lowe's in packs of two for $1.30 (see pic). After printing, just press a bolt into the hole. The head fit is tight, so you may have to use some tools (i.e. tap lightly with a hammer).