JEEP WRANGLER JL - Magnetic Phone Mount - image

Files (2)

Ball_mount.stl

STL

405.4 KB

Dash_Clip_1.stl

STL

30.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Ball_mount.stl	Mount / bracket	405.4 KB STL	Slice file	Slice file	Slice file	Ensure the ball mount is sized correctly for your magnetic mount in the slicer
Dash_Clip_1.stl	Clip	30.1 KB STL	Slice file	Slice file	Slice file	Ensure the ball mount is sized correctly for your magnetic mount in the slicer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

JEEP WRANGLER JL - Magnetic Phone Mount

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I have designed this Phone mount holder. It is held in place by a small piece of double sided Tape on the rear of the mount inside the little storage container on the dash. You will need to buy the Magnetic mount, with the ball insert as you will be printing this Ball mount that is 17mm big. You can resize it in your slicer to your specific mount ball size.