Files (1)
Based on 75% main infill across listed model files
Filament only at roughly $24/kg PETG / ASA
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 75% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| Spacer.STL | Primary model | 38.1 KB STL | 26g $0.62 | 50g $1.20 | 61g $1.47 | Ensure proper bed adhesion due to the part's shape and size |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Jeep Wrangler TJ and Cherokee Lift pucks
Shared by
Michael ChenDescription
These are coil spring spacers to lift your 1997-2006 Wrangler or Cherokee front springs 2". They have been tested to withstand 1650 psi printed with PLA @ 10% infill before deforming. Each puck should be able to support 12,900 lbs before deforming. These have not been tested yet in the real world, I'll be installing them this weekend to test them out. Print and use at your own risk! This was just an experiment to see if it could be done, turned out better than expected! These have been installed for two weeks now on a test Jeep and they're holding up perfectly. They've been down washboard dirt roads, bumpy trails and even a few street potholes. No signs of deformation, cracks, or other failures.
Print Settings
Compatible Cars
Originally published on thingiverse.com · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
