Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ABS 20% | PETG / ABS 90% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| JK_fender_clip_ABS.stl | Clip | 386.9 KB STL | Slice file | Slice file | Slice file | Print with high infill for better strength |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
JK Wrangler Fender clip
Shared by
3DPrintedCarPartDescription
I made this to attach my rear fender back onto my JK after a collision with a kangaroo tore off the left hand side fender. I ordered the replacement clips but I need to drive the car before they will arrive. Most of the dimensions are pretty close to the real deal but I did make a few dimensions a little thicker to increase the strength of the part as I wasn't sure if it would be strong enough otherwise. Print with 100% infill, supports, horizontal for better strength at the collar between the two flanges and in ABS or similar strength material that does also bend, so Nylon and PETG will likely work nicely.
Compatible Cars
Originally published on thingiverse.com by Danny Wilkinson (Coupe_) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
