Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 15% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| rubber ring.stl | Primary model | 229.0 KB STL | Slice file | Slice file | Slice file | Print the base upside down with supports to the build plate |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Land Rover Discovery 1 & 2 Cup Holders
Print this part
Check the available model and saved setup details before opening your slicer.
Files
1 hosted model file
STL
Material
PETG or ASA for durability in a car environment
Print time
Slice to calculate
Filament
Slice to calculate
Supports
supports likely for the base, verify in slicer
Infill
10-20% infill with 3-4 walls for a balance between strength and weight
Difficulty
Not rated — inspect geometry
Vehicle heat
Cabin/interior use; avoid high-heat zones
Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
3DPrintedCarPartDescription
Similar to original cup holders but a completely new design with extra features. I've removed the slot for a handle as this was never used by takeaway cups. Removed the insert to allow for larger cups up to about 80mm diameter TPU spokes keep a cup upright and more secure, even smaller cups Large threaded base screws to the holder to prevent lifting Top ring screwed in position to make the TPU ring replacable I've used countersunk M3 x 7 screws to lock the top ring and TPU in place. I've included an alternative ring that takes M3 x 7 cap head screws if you prefer. The base needs to be printed upside down with supports to the build plate. The remaining parts can all be printed without supports. All parts should load into your slicer orientated correctly. I printed PLA at 10% gyroid infill and 4 walls (with Cura) Rubber ring printed in 95a TPU You will need two small wood screws to attach this the plastic transmission tunnel of the Discovery 1 or 2. The holes should be in the same location as an original cup holder or previous clones.
Compatible Cars
Originally published on printables.com by Pugwash · License: CC BY
Browse categories
Browse other part families
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Most specific car + model + year + category matches first, with popular parts mixed in.
Range Rover Sport / Discovery 3 Console Cup Holders
Land Rover Discovery Cup Holder Insert
Land Rover LR3 Discovery 3 passenger cupholder fix
05-07 Ford Escape iPhone 5/6 cupholder drop in insert
Porsche Boxster Cup Holder
2004-2010 Hyundai Sonata Headlight Dust cap
Hyundai
