Files (1)
Based on 25% main infill across listed model files
Filament only at roughly $24/kg PETG / ASA
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| trim-clip-001.stl | Clip | 379.9 KB STL | 19g $0.46 | 21g $0.50 | 45g $1.09 | Ensure proper orientation to minimize supports |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Land Rover Discovery 1 Trim/Door Card clip
Shared by
3DPrintedCarPartDescription
This is that little red clip that goes between your door card and pushes into the plastic sockets on the door, which tend to break off when you get the door card off. There's about 10 of these per door, and they break a lot. Particularly on cold days. These hold the door cards for all four passenger doors and the rear door card into the door metalwork on Land Rover Discovery 1 200tdi and 300tdi (these both say tdi on the back) and I think also the TD5 (which does say TD5 on the back) and on the V8 models of Discovery 1. 3d printed ones in blue either side, original land rover red one in the middle for comparison.
Compatible Cars
Originally published on thingiverse.com by Tristan Scott (trs998) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
