Land Rover Discovery Rear Work Light Mount - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Rear Bumper

Land Rover Discovery Rear Work Light Mount

0 downloads133 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Just a quick, crude mount for a pair of work / off road reverse lights on a Land Rover Discovery II. Wires are fed in through the existing hole in the top of the door and routed through the existing wire tube. I wanted a mechanism to mount the lights on the rear door, without any permanent damage (no drilling holes or gluing). This just requires removing a rubber plug from an existing hole in the top of the door to run the wires through the door. The mounts are held on by the hook and then secured to the door with self-adhesive industrial strength low profile Velcro to prevent them sliding around. Printed in ABS, will see how long they stand up. Ideally, I'd make a better model, print at higher quality and paint them.. but they mount $7 lights from Amazon (Nilight 18W 4" Flood lights) a 1/4-20 x 1/2" stainless bolt & nylock nut holds the light to the mount.