Light Switch 13870519 for BMW vehicles V2 - image

Files (1)

V2Clean.stl

STL

95.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG 20%	PETG 25%	100% solid	Recommendation
V2Clean.stl	Primary model	95.3 KB STL	Slice file	Slice file	Slice file	Print with a brim for stability

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Light Switch 13870519 for BMW vehicles V2

0 downloads46 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

All credit to Anjoze, literally the same file as version 2 file of "Light Switch 13870519 for BMW vehicles by anjoze", the only change is that I cleaned up the model internals. I noticed when i tried to print in Cura 3.03 it would fill the entire inside of the model for some reason. So I opened the model in Blender3D and noticed the normals on the bottom faces were facing in the wrong direction, so I corrected those. I also faces that were used in the model inner diameters and beveled "gear" like device to be extruding into the base of the model, esstentialy splitting the internal shape of the model (in the bottom layers) from a circle, to a circle with a bunch of planes inside. So I deleted all unessasry planes/faces inside the model. I could now print it fine in Cura, so if anyone is expereinceing those above issues, this should work. Again, all credit to Anjoze for this model, it works amazingly:D.