Files (1)

Lincoln_Navigator_Shifter_Bezel_2003-2006.stl

STL

142.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Lincoln_Navigator_Shifter_Bezel_2003-2006.stl	Primary model	142.7 KB STL	Slice file	Slice file	Slice file	Ensure a clean and dry print bed for optimal adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trim Pieces

Lincoln Navigator Shifter Bezel

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I made this part for my shifter knob on my 2004 Lincoln Navigator after it cracked. I believe it will fit on 2003, 2004, 2005, and 2006 Navigators. It might also fit on a Ford Expedition, but you will know better if you have the Expedition. I am not sure if they share the same shift knob. The dealer does not sell this piece and the want to sell the complete shift knob for over $400. INSTALLATION: When installing I first test fitted and I had to sand the lower portion a bit to fit perfectly. It was minimal sanding with 100 grit sandpaper. I then dabbed a couple drops of gorilla super glue gel where the knob plastic and bezel contact. Be careful not to glue the button!