MagSafe Center Console Insert for BMW 3 Series preview

Files (1)

Center Console Insert.stl

STL

374.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Center Console Insert.stl	Primary model	374.4 KB STL	Slice file	Slice file	Slice file	Ensure a well-ventilated printing area to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

MagSafe Center Console Insert for BMW 3 Series

0 downloads28 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for durability and weight reduction

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This replaces the rubber insert that comes in the center console. Printed in PETG for heat resistance on hot summer days. For a better finish, I sanded the top with 120, 180, and 400 grit sandpaper. Pictures show it installed in a 2015 328i xDrive Sport Wagon. To power the MagSafe charger, I added a 12V outlet inside the center console connected to the rear seat 12V outlet then plugged in a 20W USB-C car charger.