Mazda Miata NB / NBFL Cup Holder - image

Files (4)

MX-5-NB-CupHolder-GloveCompartment.step

STEP

110.8 KB

MX-5-NB-CupHolder-GloveCompartment.stl

STL

2.8 MB

MX-5-NB-CupHolder-GloveCompartment_Part_1.stl

STL

9.9 KB

MX-5-NB-CupHolder-GloveCompartment_Part_2.stl

STL

531.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
MX-5-NB-CupHolder-GloveCompartment.step	Mount / bracket	110.8 KB STEP	Slice file	Slice file	Slice file	Ensure proper support settings to avoid part breakage during removal
MX-5-NB-CupHolder-GloveCompartment.stl	Mount / bracket	2.8 MB STL	Slice file	Slice file	Slice file	Ensure proper support settings to avoid part breakage during removal
MX-5-NB-CupHolder-GloveCompartment_Part_1.stl	Mount / bracket	9.9 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
MX-5-NB-CupHolder-GloveCompartment_Part_2.stl	Mount / bracket	531.2 KB STL	Slice file	Slice file	Slice file	Ensure proper support settings to avoid part breakage during removal

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Mazda Miata NB / NBFL Cup Holder

0 downloads27 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I wanted something that can hold the typical more european cups and cans. Also i didn´t like the other ways to mount a cupholder. This just requires some glue to attach the angle to the holder itself and can be customized by you if you have a different idea for mounting. Should be a easy to use item, open the glove compartment, put the ThAnG on and clamp it. Leans a slight bit forward or even be straight. Printing: Print it like it is in the complete stl, otherwise either the "ring" or the bottom part might snap when removing the support, also make sure you have tuned support settings. i´ve printed it in ABS as for now to see if i like it. You would want something heat and UV resistant as it will be in the car. Driving sharp corners and spilling the cup/can will probably not be a problem.