Mini Cooper Front License Plate Hanger (F56) - image

Files (2)

MINI_Left.stl

STL

26.4 KB

MINI_Right.stl

STL

34.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
MINI_Left.stl	Choose left variant	26.4 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
MINI_Right.stl	Choose right variant	34.1 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Front Bumper

Mini Cooper Front License Plate Hanger (F56)

0 downloads48 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Not a fan of front license plates or drilling holes in new cars. Unfortunately my state requires it. Made this to avoid tickets and mount the license plate to the front bumper without altering the car. Fits 2021 Mini Cooper S 2dr Hatchback (F56), perhaps other models from before this year, but I believe the 2022 is too different. Fit is tight, but this was made for parking lots, not while the car is in motion (although it may work for that). Attach parts between mount and license plate, then slide in right above the front bumper and it should clip into place. To remove lift straight up and out.