Files (1)

Mitsubishi_Valve_Stem_Cap.stl

STL

6.1 MB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

50g

Based on 50% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 50%	100% solid	Recommendation
Mitsubishi_Valve_Stem_Cap.stl	Cover / cap	6.1 MB STL	33g $0.79	50g $1.20	78g $1.88	Use PETG / ASA; check sealing faces and supports unlikely.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

Mitsubishi Valve Stem Cap

1 downloads268 views0 likes

Shared by

Michael Chen

Verified

Description

This is a simple remix of muzz64's design, removing the Makerbot logo and adding the Mitsubishi logo. This was made for my Evo X but will fit most car, truck and bicycle tires (Shrader valve equipped). Printed on a 0.5mm nozzle on 0.12mm resolution at 30mm/s. I would recommend a 0.4mm nozzle or smaller as the corners are much sharper. Raft recommended to avoid wobbling at the top on the print and don't use supports. Infill of 50% or more. I changed filament at layer 111 (Cura), verify in your slicer. Don't forget to share your makes!