Files (2)

MK3_Dash_Gauge_Pod_v5.stl

STL

115.6 KB

MK3_Left_Center_Vent_Gauge_Pod_v13.stl

STL

268.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
MK3_Dash_Gauge_Pod_v5.stl	Printable file	115.6 KB STL	Slice file	Slice file	Slice file	Ensure proper fit by checking the gauge pod's dimensions and the car's dashboard layout
MK3_Left_Center_Vent_Gauge_Pod_v13.stl	Choose left variant	268.3 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

MK3 Volkswagen 52mm Gauge Pods

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Two 52mm gauge pod mounts I made for my 98 Jetta TDI. Sorry for the bad photo, I'll take another in daylight. (gauge backlights are being changed out for green to match the dash) One goes where the heated seat buttons would go but you must cut away behind it to make it fit. Then just insert the top of the pod first and push in the bottom dimple side and it fits nice and tight. The other one is in place of the left center vent. I don't use the face vents so I didn't care if it got blocked some. It's not perfect but close enough for me. It doesn't swivel, it's pretty tight. Behind this where the vent insert meets the dash vent tunnel is where I routed my wires through. Just pushed up where they meet and fed my wires through. I printed both of these in PETG, PLA might work for a while but tends to deform in the summer plus it's in the dash which gets warm.