MK7 Transit Sliding Door Rail End Cap - image

Files (2)

Cap_And_Pin_MK7_Transit_Sliding_door_end_cap.stl

STL

52.4 KB

pin.stl

STL

30.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Cap_And_Pin_MK7_Transit_Sliding_door_end_cap.stl	Cover / cap	52.4 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
pin.stl	Printable file	30.9 KB STL	Slice file	Slice file	Slice file	Use a raft to prevent the pin from falling over during printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

MK7 Transit Sliding Door Rail End Cap

0 downloads167 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement for the MK7 Ford Transit Sliding Door Rail End Cap. The pin is a snug fit but with a push it will interlock between the cap and the rail and not vibrate out. I printed this in PLA with no issues (Use a raft as it stops the pin falling over). Also I have included a separate upload for just the pin, in case it breaks on install and you only want to print the pin again. Thanks.