Model A Ford Dashboard organizer - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Model A Ford Dashboard organizer

0 downloads46 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a magnetic dashboard design for the Ford Model A. Mine is a 1929 and it fits perfectly with the phone and battery bank next to the steering column and hanging down. I recommend putting some thin plastic or fabric behind it to protect the paint. You will also need 4 16lb magnets, 2 25lb magnets, and 6 each of 7mm x 3/4" screws, 7mm washers, and 7mm nylon nuts. Also keep in mind this was designed to hold the moto G Power and a generic 20000mAh battery bank from amazon. You may need to play with it a bit to fit your devices.