Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| MR2_AC_KNOB.stl | Primary model | 2.1 MB STL | Slice file | Slice file | Slice file | Print with the knob facing up to minimize support material |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
MR2 AC Fan Speed Control Knob
Shared by
3DPrintedCarPartDescription
This is the knob for the AC Climate control in the Gen 2 MR2. This replaces your old knob and comes with a small section for light to shine through just like the OEM knob. I had to sand, acetone dip, and then sand again to get the matte finish but you can do whatever you want. I would print with the knob facing up if I did it again, but be careful of the the supports that you will get on the bottom. There is a little metal insert in the old knob you will have to insert into this new one. Otherwise you will have to go into your favorite cad software and close off the space between the two triangles. Good Luck and I hope this helps you.
Compatible Cars
Originally published on thingiverse.com by Christian Gotsch (pieindaface) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
