Mustang 2.5in Wheel Center Cap Hub Cap - image

Files (1)

Mustang_2.5in_Wheel_Center_Cap_Hub_Cap.stl

STL

236.9 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

18g

Based on 25% main infill across listed model files

Material cost

$0.42

Filament only at roughly $24/kg PETG / ASA

Print time

30m–50m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Mustang_2.5in_Wheel_Center_Cap_Hub_Cap.stl	Cover / cap	236.9 KB STL	16g $0.39	18g $0.42	38g $0.92	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Accessories

Mustang 2.5in Wheel Center Cap Hub Cap

0 downloads73 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Mustang 2.5in Wheel Center Cap Hub Cap. Fits my 2001 Ford Mustang Convertible. - 2.5" diameter (6.3cm, 63mm) - Reinforced retention tabs. Fits very snug, but removes without breaking. - This was first attempt to print with M3D's ABS-R filament. It came out somewhat grainy, but still looked good on the wheel. - Spray painting it with chrome paint did not look good, but it wouldn't take much work to smooth the piece prior to painting. TinkerCAD: - https://www.tinkercad.com/things/6G4AudJacmC