Files (1)

jeep_cherokee_nexus7.stl

STL

166.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
jeep_cherokee_nexus7.stl	Primary model	166.0 KB STL	Slice file	Slice file	Slice file	Ensure a snug fit by adjusting the model's scale if necessary

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Nexus 7 Mount - Jeep Cherokee

0 downloads52 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a remix of the Nexus 7 (2013) Auto GPS Mount by mccand. I needed to flush mount my Nexus 7 in my Cherokee and there were no available mounts that didn't stick out and look tacky. I was able to strip off the extra parts from this mount and make it a little more lightweight. It attaches using the two thin tabs off the top. You will need to remove the bezel from the Cherokee and unscrew the buttons which are attached with 4 hex screws. I used a lighter to soften the PLA of each tab and was able to bend them down behind the bezel. Once the buttons are screwed back in place, the tablet holder is very snug.