Opel Astra L Brodit car specific holder for Opel Astra L center console preview

Files (1)

astra-clip-70mm-brodit v3.stl

STL

417.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG 20%	PETG 25%	100% solid	Recommendation
astra-clip-70mm-brodit v3.stl	Clip	417.4 KB STL	Slice file	Slice file	Slice file	Ensure a well-ventilated printing area to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Opel Astra L Brodit car specific holder for Opel Astra L center console

0 downloads22 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for durability, 1.2-1.6mm walls

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY-SA

Commercial use allowed

Attribution required

Safety/IP review

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Since Brodit doesn't offer any other car-specific holders other than one for the left side of your steering wheel in the air vent, I decided to make a model for your center console. I recommend printing it with PETG because of the high interior temperature during summertimes.