Files (3)

phone-a3.stl

STL

105.5 KB

phone-assembly2.STL

STL

3.5 MB

phone-b2.STL

STL

808.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
phone-a3.stl	Printable file	105.5 KB STL	Slice file	Slice file	Slice file	Ensure the model is scaled correctly to fit your specific phone and car model
phone-assembly2.STL	Printable file	3.5 MB STL	Slice file	Slice file	Slice file	Ensure the model is scaled correctly to fit your specific phone and car model
phone-b2.STL	Printable file	808.2 KB STL	Slice file	Slice file	Slice file	Ensure the model is scaled correctly to fit your specific phone and car model

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Phone holder for Ford coin slot

0 downloads36 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I made this for my Ford Expedition (it is also on F-150's). It fits the coin holder looking thing to the right of the steering wheel. This is where a 4WD switch would go but since I dont have 4WD, there is this blank plug. I made this 'thing' to fit in the opening and hold my phone right in front of the air vent. Feel free to change the size to make it fit better, and to fit your phone. I used play-doh to push in there and measure it after I took it out. Very rough estimations, but it works for my car. I added half a velcro strip to keep the phone from wiggling. Update: 6/20/2020 I combined the two pieces into one file. I had an issue where the summer heat would let it bend. Now, with one piece it should stand up to the heat better. Also made the blue one in PETG. New feature, added a QI wireless charger. I'm not sure if they are all the same size, but this is the one I bought and fits nice. Phone drops in and starts charging. https://www.amazon.com/gp/product/B079KZ49PJ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1